General - Comtech EF Data Vipersat SLM-5650A User Manual

U
SING THE
(WSI)

General

This chapter describes the use of the WSI for configuring and monitoring the
SLM-5650A Modem Router in a Vipersat network. Each web page related to an
SLM-5650A operating in Vipersat mode is presented, along with a detailed
description of the available commands. For descriptions of all other screens,
refer to the SLM-5650A Installation and Operation Manual.
Web (HTTP) access to the SLM-5650A is provided through the NP (Network
Processor) card Ethernet traffic switch, and requires login with password. The
physical LAN connection is made to one of the following RJ-45 interfaces:
The pages presented in this document are as they appear when the SLM-5650A
is accessed using the Microsoft Internet Explorer web browser.
A Web connection is made by entering the target SLM-5650A NP IP address
into the browser address field. The factory default IP address for a Vipersat-
enabled unit is
prompt. The factory defaults are:
C h a p t e r 3 - U s i n g t h e W eb S er v e r I n t e r f a c e ( W S I )
W S
EB
• When operating with Router Mode set to Router, one of the four Ethernet
ports, 1–4, on the NP card should be used.
• When operating with Router Mode set to BPM (Bridge Point-to-
Multipoint), network management can only be performed using the J5
Ethernet port on the base modem.
192.168.1.177/24
I
ERVER NTERFACE
. The SLM-5650A responds with a Login
C
H A P T E R
3-1