Set The Vipersat Working Mode; Figure 2-3 Front Panel, Slm-5650A Modem - Comtech EF Data Vipersat SLM-5650A User Manual

Tip: The network administrator will have the FAST Feature codes. These are
Caution: Upgraging the FAST features will cause a modem reboot and

Set the Vipersat Working Mode

The operating parameters that will be configured in the SLM-5650A are, in part,
determined by the role the modem is to fill in the network, as shown in table 2-1
and table 2-2.
Use the following procedure to configure an SLM-5650A to the network role it
is to fill in a Vipersat network.
1.
2.
C h a p t e r 2 - Q u i c k S t a r t C o n f i g u r a t i o n
The FAST Feature codes are entered using the front panel of the modem
(figure 2-3). With the keypad, select
Utility -> FAST -> Configuration -> Enter NP Code
Enter the provided 20 digit code.
Figure 2-3
generated and stored by the unit serial number for the target SLM-5650A.
The target unit's serial number can be found on the rear of the unit
chassis, or on the FAST code menu.
reconfiguration of all modem parameters.
Return to the Admin submenu and select Vipersat Mode (figure 2-4).
Select the designated Mode by clicking on the corresponding radio button,
then click on the Submit button.
This will set the modem functionality to reflect the selection.
Expansion Unit
When configured as an expansion unit, either as a Hub (switched) or as a
Remote (mesh), the SLM-5650A is set up so that the demod is in SCPC
mode and available as a resource for dedicated communications with the
other end of the satellite link.
Front Panel, SLM-5650A Modem
I n i t i a l C o n f i g u r a t io n
.
2-5