Fujitsu MAU3147RC SERIES Technical Manual page 338

Sense Data and Error Recovery Methods
Table 5.4 Additional Sense Code and Additional Sense Code Qualifier (2/6)
C* Q* Name
0E 02 Information Unit Too Long
11 01 Read retries exhausted
02 Error too long to correct
13 00 Sync Mark not found for Data
field
14 00 Record entity not found
01 Record not found
15 01 Mechanical positioning Error A seek error occurred in the drive.
02 Positioning Error detected by
read of medium
17 01 Recovered data with retries
02 Recovered data with positive
head offset
03 Recovered data with negative
head offset
06 Recovered data without ECC:
data auto-reallocated
08 Recovered data without ECC:
recommended rewrite
18 00 Recovered Data with Error
Correction Applied
19 02 Defect list error in primary list An error was detected during reading of the defect list (P List).
03 Defect list error in grown list
80 Log information read error
81 Log information write error
84 Mode Select SA write Error
Ax Drive Parameter SA write
Error
Bx Drive Parameter SA write
Error
1A 00 Parameter list length error
* C: Additional Sense Code, Q: Additional Sense Code Qualifier
5-8
Explanation
The received write data is longer than the stipulated length.
Unrecovered error was detected during data read (retry out).
Unrecovered error was detected during data read (BCRC error
detected by SAS/IF)
SM (Sync Mark) could not be detected in the Data area.
Expected data from a sector was undetected. (LBA compare
error detected by FMT)
The target data block (sector) could not be detected.
LBA did not match due to Cylinder number's mismatch.
A data error was recovered from by reading was retried.
A data error was recovered by read retry with offsetting head to
positive direction.
A data error was recovered by read retry with offsetting head to
negative direction.
Automatic alternate allocation was applied without ECC
correcting a data error.
Rewriting to the same sector was performed without ECC
correcting a data error.
A data error was recovered by read retry with ECC corrercting.
An error was detected during reading of the defect list (G List).
An error was detected during reading of statistical information.
A write error was detected during writing of statistical
information.
An error was detected during writing of SA information (Mode
Select Paramenter)
An error was detected during writing of SA information (Device
Information)
An error was detected during writing of SA information (Device
Information)
There is a mistake in the indication of the parameter list page
length.
Sense
key
B
3, B
3, B
1, 3, B
1, 3, B
1, 3, B
1, 3, B
1, 3, B
1
1
1
1
1
1
3
3
3
3
3
3
3
5
C141-C009