Table of Contents
Advertisement
Command Specifications
Table 4.116 lists the format of response data transferred to the INIT from the IDD
by this command. The response data are configured from a 4-byte "Page header"
and the "Page parameters" which follow it.
Table 4.116 RECEIVE DIAGNOSTIC RESULTS command:
Byte
0
1
Header
2
3
4
5
Page
Parameters
~
~
n
4-176
Exercise caution in the following points when using this command.
1.
In order to avoid damage to the results of SEND
DIAGNOSTIC command execution (response data) from a
command issued by another INIT during the interval until this
command is issued, either this command should be executed
after the IDD is reserved.
2.
Response data are valid only when "0" is specified in the
"SelfTest (self test)" bit and after a SEND DIAGNOSTIC
command which specifies a specific operation in the parameter
list is executed, with the IDD transferring response data
showing the execution results of the latest SEND
DIAGNOSTIC command. Also, even if this command is
executed, the response data in not cleared, and remains valid
until the next SEND DIAGNOSTIC command is executed.
3.
If this command is issued when valid response data do not exist,
the IDD transfers a maximum of 4 bytes of X '00' data to the INIT.
response data configuration
Bit
7
6
0
0
Page Parameter Length (MSB)
~
~
5
4
3
Page Code
0
0
0
Page Parameter Length (LSB)
Parameter
2
1
0
0
0
0
~
~
C141-C009
Advertisement
Table of Contents
