Table of Contents
Advertisement
Command Specifications
a. Parameter code
This field identifies the log parameter being transferred for that log page.
b. Byte 2
1) DU (Disable Update)
"1": The IDD does not update the log parameter value except in response to a
"0": The IDD updates the log parameter value to reflect all events that are
2) DS (Disable Save)
"1": The IDD does not support saving that log parameter in response to LOG
"0": The IDD supports saving for that log parameter. The IDD saves the
3) TSD (Target Save Disable)
The IDD does not support this bit. For LOG SENSE command (See 4.1.16),
the IDD always report zero. Also, for this command, the IDD accepts this bit
value of "1", but ignores its functionality.
4) ETC (Enable Threshold Comparison)
The IDD does not support this bit. For LOG SENSE command (See 4.1.16),
the IDD always report zero. Also, for this command, the IDD accepts this bit
value of "1", but ignores its functionality.
5) TMC (Threshold Met Criteria)
This field is ignored when "ETC" bit is 0. For LOG SELECT command (See
4.1.15), the IDD accepts this field value of other than "00b", but ignores its
functionality.
6) LBIN
This bit is only valid if the "LP" bit is one. If the "LP" bit is one and this bit
is zero then the list parameter is a string of ASCII graphic codes.
If the "LP" bit is one and this bit is one then the list parameter is a list of
binary information.
4-90
LOG SELECT command that specifies a new value for the parameter.
noted by that parameter.
SELECT or LOG SENSE command with an "SP" bit of one.
current parameter value in response to LOG SELECT or LOG SENSE
command with a "SP" bit of one.
C141-C009
Advertisement
Table of Contents
