Figure 4.2 Correction Of The Defect Descriptor - Fujitsu MAU3147RC SERIES Technical Manual

Command Specifications
If this command is terminated with a CHECK CONDITION status,
the additional sense code/additional sense code qualifier in the
sense data is other than "No defect spare location available [=32-
00], and a valid logical block address (other than X 'FFFFFFFF') is
displayed in the "Command inherent information" field, it is
necessary for the INIT to reissue this command by the following
procedure after executing recovery processing (shown in Section
5.2) in accordance with the contents of the sense data.
1.
Delete

Figure 4.2 Correction of the defect descriptor

2. Change the "Defect List Length" in the header and add the new "Defect
descriptor list" corrected in 1), then reissue the REASSIGN BLOCKS
command.
4-160
Delete the defect descriptors which precede the defect
descriptor that specifies the logical block address displayed in
the "Command inherent information" field of the sense data
from the defect descriptor list specified in this command, and
leave that defect descriptor in the list.
Defect Descriptor List
XXXX
Logical block address that indicates the "Command inherent
information" field of the sense data.
C141-C009