Concluding Steps; Removing A Server Blade; Preliminary Steps - Fujitsu PRIMERGY BX924 S3 Upgrade And Maintenance Manual

Basic hardware procedures
4.4.3

Concluding steps

V
Note on network settings recovery
When replacing network controllers or onboard CNA, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing the
controller.
Ê Insert the server blade in the system unit see section
blade in the system unit" on page
Ê Restore the BIOS settings as described in section
on page 85
Ê Restore the iRMC settings as described in section
settings" on page
I
In order to enable ServerView Operations Manager and ServerView
Installation Manager to identify the system, it is necessary to program the
chassis ID prom using the "ChassisIDProm Tool" after installing the new
Server Blade.
4.5

Removing a server blade

V
CAUTION!
For safety information, please refer to chapter
page 31.
4.5.1

Preliminary steps

Ê If applicable, open the rack door as described in section
door" on page
Ê Shut down and power off the server blade as described in section
down the server blade" on page
58
85.
53.
Upgrade and Maintenance Manual
62.
"Restoring BIOS settings"
"Important information" on
54.
"Installing the server
"Restoring iRMC
"Opening the rack
"Shutting
BX924 S3