Table of Contents
Advertisement
4.7
Closing the server blade
V
CAUTION!
Before attaching the cover, make sure no unnecessary parts or tools
●
are left inside the server.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY BX924 S3 server blade must not run while the cover is
removed.
For further safety information, please refer to chapter
●
information" on page
Figure 10: Closing the server blade
Ê Place the cover on the server blade housing such that it lies flush with both
sides, leaving a gap of approx. 1-2 cm from the front frame.
Ê Push the cover in the direction of the arrow until it snaps into place.
BX924 S3
31.
Upgrade and Maintenance Manual
Basic hardware procedures
"Important
61
Advertisement
Table of Contents
