Swap; Call Forward - Mitel Navigator User Manual

Swap

To call another party when you are in an established two-party call:
1. Press (TRANS/CONF).
2. Dial the number.
To alternate between the two parties:
• Press the Trade softkey.

Call Forward

Call Forward lets you redirect incoming calls to an alternate number. You can select one of
the following forwarding options:
• Always redirects all incoming calls regardless of the state of your telephone.
• B-Int redirects internal calls when your telephone is busy.
• B-Ext redirects external calls when your telephone is busy.
• NA-Int redirects internal calls after several rings if you don't answer.
• NA-Ext redirects external calls after several rings if you don't answer.
Note: For information about "I Am Here?", see Call Forward – Remote.
To program Call Forward:
1. Press (SUPERKEY).
2. Press the No softkey until "Call Forwarding?" appears.
3. Press the Yes softkey.
4. Press the Next softkey until the type of Call Forward appears (see above).
5. Press the Review softkey.
6. If a number is already programmed, press the Change softkey.
7. Press the Program softkey.
8. Dial the destination number.
9. If you make an error while dialing, use the <−−− softkey to backspace and correct the
number.
10. Press the Save softkey.
To turn Call Forward on and off (once it has been programmed):
1. Press (SUPERKEY).
2. Press the No softkey until "Call Forwarding?" appears.
3. Press the Yes softkey.
4. Press the Next softkey until the type of Call Forward appears.
5. Press the Review softkey.
6. Press the Change softkey.
42