Record A Call - Mitel Navigator User Manual

Phone state before the
Direct Page arrives
Phone is idle, and (MUTE) is
OFF
You are on a handset or headset
call, and (MUTE) is OFF
You are on a MUTED
handset/headset call, OR, you
are on a Handsfree call
To end a Direct Page call, do one of the following:
• Hang up the handset to end a handset call.
• Press
(SPEAKER) to end a handsfree call.
• Press
(CANCEL).
Note: When the Handsfree Direct Page call ends, the
state it was in before the call was established.

Record a Call

This feature uses your voice mail system to record your phone conversations.
Note: You may be required by law to inform the other party that you are recording the
conversation. For specific instructions, consult your system administrator.
To start recording while on a two-party call:
• Press the Record Call key.
See Personal Feature Keys on page 31 for instructions on programming a Record Call
feature key to your phone.
Note: Your system may be programmed to automatically begin recording external calls when
you or the other answers.
To answer the Direct Page (indicated by a single burst of tone)
1. Check that (MUTE) is ON solid.
2. Lift the handset
or
3. Press (MUTE) to answer in Handsfree mode.
(The light turns OFF.)
4. Speak to the paging party.
1. Check that (MUTE) is flashing.
2. Press (MUTE).
The light turns ON solid, and you are now speaking to the
paging party and have MUTED your handset/headset call.
3. Speak to the paging party.
4. Press (MUTE) to alternate between handset and handsfree
calls.
•
The party paging you receives a busy tone.
Handsfree Answerback does not interrupt your call.
54
(MUTE) key light returns to the