Maintenance - Buffalo TeraStation III TS-IXL User Manual

Maintenance

Maintenance
Notification
SMTP Server
Address
SMTP Port No.
Authentication
Email
Type
Notification
POP3 Server
Click "Modify
Address
Settings"
POP3 Port No.
to change
SSL/TLS
settings.
Click
Username
"Send Test
Password
Message"
to send a Subject
test email
to the email Recipient(s)
address
which has Report
been set.
Syslog Syslog
Click "Modify
Settings"
to change
settings.
TeraStation IS Setup Guide
Enable to use Email notification.
Enter the address of your SMTP mail server.
Enter the SMTP Port Number. If this is left blank, the standard port number (25) is used.
If user authentication is set to "Disabled" or "POP before SMTP", then port 25 is used
regardless of the number entered in this field.
Select Authentication Type from "POP before SMTP", "LOGIN (SMTP-AUTH)", and "CRAM-
MD5(SMTP-AUTH/CRAM-MD5)".
Enter the address of the POP3 email server
Enter the POP3 Port Number. If this is left blank, the standard port number (110) is used.
When "LOGIN (SMTP-AUTH)" and "CRAM-MD5 (SMTP-AUTH/CRAM-MD5)" are selected for
Authentication Type, specify either "SSL" or "TLS".
Enter the username for authentication.
Enter the password for authentication.
Specify the subject line that emails will be sent with. Alphanumeric characters are
supported. Do not use two-byte characters.
Enter the email address of the recipient, and click "Add". You can register up to 5 email
addresses as recipients.
Select the contents for email notifications.
• HDD Status Report
Sends the drive status.
• Fan Failure
Sends a message if a fan error occurs.
• Disk Error
Sends a message if a drive error occurs.
• System Alert
Sends a message when the TeraStation is rebooted or shut down, or its RAID
configuration is changed.
You may elect to send logs to a syslog server. "Enable" Log information transmission,
enter the IP address of the syslog server, and select "Save" to transmit logs to a syslog
server.
52