Configuring.access.restrictions.for.an.individual.volume - Buffalo TeraStation III TS-IXL User Manual

Configuring Access Restrictions for Individual
Volumes
1
2
3
4
5
Click "Save".
6
Turn the iSCSI service back on again.
Note:
Access Restrictions by Mutual Authentication using User name and Password
Use the following settings to set access restrictions by mutual authentication in addition to the normal
access restrictions:
In the screen described in step 2, check "Mutual Authentication" and set any password you want for
"Password (Mutual Authorization)". Select "Mutual Authorization" for "User Authorization". The screen
to enter the mutual authentication password will open. Enter the password you set.
Changes to access restriction settings will not take effect until the iSCSI service has been turned off and
then on again.
You've configured access restrictions for a volume.
TeraStation IS Setup Guide
Turn of f the iSCSI Service.
Navigate to "iSCSI Volumes" - "iSCSI Volumes".
Select the volume that you want to set access restrictions for.
To restrict access by user names and passwords, enable "IP
Address Restriction", and set the user name and password.
To restrict access by IP Address, enable "IP Address
Restriction", and enter the IP addresses that are to be
allowed access. Separate each IP address by a comma.
Example: 192.168.11.1,192.168.11.2
27