Maintenance - Buffalo TeraStation III iSCSI TS-IXL User Manual

Maintenance

Maintenance
Email Notification
Click Modify Settings to change
settings.
Click Send Test Message to send
a test email to the email address
which has been set.
Syslog
Click Modify Settings to change
settings.
TeraStation III iSCSI User Manual
Notification Select whether using Email notification feature or not.
SMTP Server Address Enter mail server address in SMTP Server Address field.
SMTP Port No. Enter SMTP Port No.
If this is left blank, the standard port number (25) is used. If
Authentication Type is set to Disabled or POP before SMTP, then port 25
is used regardless of the number entered in this field.
Authentication Type Select from POP before SMTP, LOGIN (SMTP-AUTH), or CRAM-MD5(SMTP-
AUTH/CRAM-MD5).
POP3 Server Address Enter mail server address in POP3 Server Address field.
POP3 Port No. Enter POP3 Port No.
If this is left blank, the standard port number (110) is used.
When LOGIN (SMTP-AUTH) or CRAM-MD5 (SMTP-AUTH/CRAM-MD5) are
SSL/TLS
selected for Authentication Type, specify either SSL or TLS.
Username Enter the username for authentication.
Password Enter the password for authentication.
Subject Specify the subject line that emails will be sent with. Use alphanumeric
characters only. Do not use multi-byte characters.
Recipient(s) Enter the email address of the recipient, and click Add. You can register
up to 5 email addresses as recipients.
Report Select the contents for email notifications.
• HDD Status Report
• Fan Failure
Sends when the fan error is recognized.
• Disk Error
Sends when the hard drive error is recognized.
• System Alert
Syslog You may select to send logs to a syslog server. Select Enable for Syslog
Transfer, enter the IP address of the syslog server in Syslog Server IP
Address field, and select Save to transmit logs to a syslog server.
Sends the condition of the hard drives at the specified time on HDD
Status Report.
Sends when system is rebooted or shut down, or RAID configuration is
changed.
52