Buffalo TeraStation III TS-IXL User Manual page 58

Status
Displays the current status when changing the settings or formatting drives.
Display
HDx Warning I11
Bad Sectors
OperationModeI12
DEGRADE MODE
RAID
ARRAYx Formatting
RAID
ARRAYx Checking
RAID
ARRAYx Scanning
RAID
ARRAYx Creating
RAID
ARRAYx Resyncing
RAID
ARRAY xRebuilding
RAID
ARRAYx 0 Filling
DISK
DISKx Formatting
DISK
DISKx 0 Filling
SYSTEM
I23
Initializing
Network
Setting Config
SYSTEM
I25
F/WUPDATING
Web Setting
Initializing
iSCSI I30
Connected
Press FuncSW I31
New Diskx ready
Set From Web I32
New Diskx ready
These examples show the two-line display of a TS-IXL TeraStation. Rack-mount TS-RIXL TeraStations
have a slightly different LCD display, with the two lines of information displayed on a single line. Scroll
horizontally to view the rest of the information.
TeraStation IS Setup Guide
Meaning
The bad sectors in the Xth hard drive are serious. Replace the Xth hard drive.
The RAID array is running in degraded mode.
I13 Formatting the Xth RAID array.
I14 Checking the Xth RAID array.
I15 Scanning the Xth RAID array. Transfer speeds will be slower until this
finishes.
I16 Creating the Xth RAID array.
I17 Recycling the Xth RAID array. Transfer speeds will be slower until this
finishes.
I18 Rebuilding Xth RAID array. Transfer speeds will be slower until this finishes.
I19 Deleting data completely by filling zeros into Xth RAID array.
I20 Formatting the Xth hard drive.
I22 Deleting data in the Xth hard drive.
Initializing the system.
I24 Configuring network settings (such as querying DHCP for an IP address).
Updating the TeraStation's firmware. Do not turn off the TeraStation until
the update is complete.
I26 Initializing web configuration.
A computer is connected to the volume. Before turning off the computer,
disconnect the TeraStation (page 11).
The new drive is ready to mount. Press the function button to mount it.
The new drive is ready to configure. Use the configuration utility to
restructure the drive or rebuild a RAID array.
57