Electric Fuel Pump/Fuel Level Sensor - Arctic Cat Prowler XTZ 2009 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
NOTE: Always use a large container and have
sufficient floor drying material available when
draining the coolant in case of coolant spillage.
2. Remove the coolant hoses from the water pump;
then remove two cap screws securing the water
pump to the crankcase.
3. Remove the water pump from the engine.
INSTALLING
1. Install a new O-ring onto the water pump and
lightly coat with clean engine oil.
2. Install the water pump assembly onto the engine
aligning the flat drive on the water pump to the
slot in the driveshaft.
www.mymowerparts.com
Back
4-10
GZ093A
GZ230A
GZ252C
Back to TOC
! CAUTION
Do not force the water pump housing into the crank-
case or sever engine damage may occur.
3. Secure the water pump with the two cap screws
and tighten securely; then connect the coolant
hoses and secure with hose clamps.
4. Tighten the coolant drain plug securely; then fill
the cooling system with appropriate mixed coolant
and install the radiator cap.
5. Start the engine and check for coolant leaks; then
add coolant if necessary to proper level.
! CAUTION
After operating the ATV for the initial 5-10 minutes,
stop the engine, allow the engine to cool down, and
check the coolant level. Add coolant as necessary.
Electric
Fuel Pump/Fuel Level
Sensor
The electric fuel pump and fuel level sensor are not
serviceable components. If either component fails, it
must be replaced.
TESTING
! WARNING
Whenever any maintenance or inspection is made
on the fuel system during which there may be fuel
leakage, there should be no welding, smoking, open
flames, etc., in the area.
AT THIS POINT
Prior to removing the electric fuel pump, the follow-
ing check should be performed to determine that
removal is necessary.
Back to Section TOC
GZ252D
Next