Floor; Belly Panel - Arctic Cat Prowler XTZ 2009 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
INSTALLING
Place the appropriate fender into position and secure
with existing hardware.
REMOVING
1. Remove the seats and center console.
2. Remove twelve cap screws and two self-tapping
screws securing the floor to the frame.
3. While pulling forward on the upper-rear of the
floor, lift the rear part of the floor above the seat
lock stud.
NOTE: To aid in removing, insert a small wood
block to hold in position.
www.mymowerparts.com
Back
8-12

Floor

Back to TOC
PR311A
4. From the opposite side of the vehicle repeat step 3;
then lift the rear of the floor up and lift the floor
out of the vehicle.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean the floor with soap and water.
2. Inspect the floor for cracks or holes.
INSTALLING
1. Place the front of the floor into position in the
vehicle first; then lower the rear and push past the
seat lock studs.
2. Secure the floor with twelve cap screws and two
self-tappings screws.
3. Install the center console and seats making sure
PR163
the seats lock securely into position.
REMOVING
1. Remove the body screws securing the belly panel
to the underside of the frame.
Back to Section TOC

Belly Panel

PR164
PR165
Next