Taillight Assembly; Seats; Www.mymowerparts.com - Arctic Cat Prowler XTZ 2009 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. Inspect the cargo box gate latches for smooth
operation.
INSTALLING
1. With the help of an assistant or an adequate lift, set
the cargo box into position on the frame; then posi-
tion the two upper pivot housings between the cargo
box and frame. Lightly grease the pivot housings.
2. Align the holes in the upper pivot housings with
the holes in the cargo box; then install the lower
pivot housings and secure with the four shoulder
cap screws. Tighten to 20 ft-lb.
3. Raise the cargo box; then connect the lift support
to the frame, install the cap screw and nut, and
tighten the nut securely.
4. Lower the cargo box and lock into position.

Taillight Assembly

REMOVING
1. Remove two torx-head screws securing the tail-
light assembly to the rear canopy tube; then rotate
the taillight assembly left or right to allow the con-
nector to clear the access opening.

www.mymowerparts.com

Back
8-14
PR056
Back to TOC
2. Disconnect the three-prong connector from the
bulb socket and remove the taillight assembly.
INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect wiring harness, three-prong connector,
lens, base, cap screws, and socket for damage.
2. Inspect all wires for corroding, pinching, and
cracking.
3. Inspect the bulb for wattage, voltage, and proper
operation.
INSTALLING
1. Connect the three-prong connector to the bulb
socket; then place the taillight assembly into posi-
tion on the rear canopy tube.
2. Install the two torx-head screws and tighten securely.

Seats

REMOVING/INSTALLING
1. To remove a seat, pull the seat lock lever up. Raise
the front of the seat and slide it forward.
2. To install a seat, slide the rear of the seat into the
seat retainers and push down firmly on the front of
seat. The seat should automatically lock into posi-
tion.
Back to Section TOC
Next