Hood; Fenders - Arctic Cat Prowler XTZ 2009 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all bumper components with hot, soapy
water.
2. Inspect all welds for cracking or bending.
INSTALLING
Place the bumper assembly into position on the frame;
then secure with the four cap screws and nuts making
sure the flat washers and lock washers are properly
positioned. Tighten securely.
REMOVING
1. Open the hood; then disconnect the four headlight
connectors and remove two nylon ties.
2. Loosen but do not remove the four cap screws and
flange nuts securing the hood hinge to the frame;
then lower the hood.
3. Finish removing the cap screws and flange nuts
(from step 2); then remove the hood assembly.
www.mymowerparts.com
Back

Hood

Back to TOC
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all hood components with soap and water.
2. Inspect the hood for cracks and/or loose fasteners.
3. Inspect for any missing decals.
INSTALLING
1. Place the hood into position on the vehicle; then
install the two outside cap screws and flange nuts.
Finger-tighten only at this time.
2. Open the hood; then install the remaining two cap
screws and flange nuts. Tighten all four securely.
3. Connect the four headlight connectors; then secure
the wires with two new nylon ties.
PR328A
REMOVING
PR332A
Remove three torx-head screws securing each fender
to the frame. Account for a stiffener bracket on the
front fenders.
Back to Section TOC

Fenders

PR332
8
PR332B
Next
8-11