Checking/Adjusting Front Wheel Alignment; Front Bumper Assembly - Arctic Cat Prowler XTZ 2009 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
9. Install the wheel; then using a crisscross pattern,
tighten to 45 ft-lb.
10. Remove the vehicle from the support stand.
Checking/Adjusting
Front Wheel Alignment
NOTE: All measurements and adjustments must
be made with the vehicle unloaded.
Mark the center-line of the front tires at the front and
rear of the tire; then using a tape measure, measure and
record the distance between the marks at the front and
rear. The front measurement should be 6-12 mm
(1/4-1/2 in.) greater than the rear measurement
(toe-out).
To adjust the wheel alignment, use the following pro-
cedure.
1. Center the steering wheel; then using an open-end
wrench to hold the tie rod ends, loosen the
right-side and left-side jam nuts.
www.mymowerparts.com
Back
8-10
PR377B
PR087A
Back to TOC
! CAUTION
Always use a wrench to hold the tie rod ends when
loosening or tightening the jam nuts or damage to
the boots could occur.
2. Turn the left-side and right-side tie rods in equal
increments to achieve the proper toe-out; then
tighten the jam nuts securely.

Front Bumper Assembly

REMOVING
Remove four cap screws and nuts. Account for four
lock washers and eight flat washers.
Back to Section TOC
PR085A
PR086
PR327A
Next