Table of Contents
Advertisement
Installing the Switch
This section contains information that you need to install and set up the switch. It covers the following topics:
Before You Begin
Positioning the Switch
Rack-Mounting or Free-Standing
Supplying Power to the Switch
Checking for Correct Operation
Using SFP Transceivers
Performing Spot Checks
Before You Begin
Before installing or removing any components from the switch or carrying out any maintenance procedures,
read the Safety and Compliance Guide chapter in this guide.
Positioning the Switch
The switch is suitable for use in an office environment where it can be free-standing or mounted in a
standard 19-inch equipment rack.
Alternatively, the switch can be rack-mounted in a wiring closet or equipment room. A mounting kit,
containing two mounting brackets and four screws, is supplied with the switch.
When deciding where to position the switch, ensure that:
It is accessible and cables can be connected easily.
Cabling is away from sources of electrical noise. These include lift shafts, microwave ovens, and air
conditioning units. Electromagnetic fields can interfere with the signals on copper cabling and
introduce errors, thereby slowing down your network.
Water or moisture cannot enter the case of the unit.
Air flow around the unit and through the vents on the side of the case is not restricted (HP recommends
that you provide a minimum of 25 mm (1 in.) clearance).
The air is as free from dust as possible.
Temperature operating limits are not likely to be exceeded. HP recommends that the unit is installed in
a clean, air conditioned environment.
NOTE:
It is always good practice to wear an anti-static wrist strap connected to a ground point when installing
network equipment. If one is not available, try to keep in contact with a grounded rack and avoid touching
the unit's ports and connectors, if possible. Static discharge can cause reliability problems in your
equipment.
5
Hide quick links:
Advertisement
Table of Contents
