HP V1905 Series Getting Started Manual page 34

Defining Port Settings

Viewing Port Settings

Viewing Port Details

Defining Port Settings
The Port Setup Page allows network managers to configure port parameters for specific ports.
Click Port  Administration  Setup. The Port Setup Page opens.
Figure 68 Port Setup Page
The Port Setup Page contains the following fields:
Table 55 Port Setup Page item description
Item
Port State
Flow Control
Speed
Duplex
Description
Enables and disables the port. The possible field values are:

No Change: Retains the current port status.

Enabled: Enables the port.

Disabled: Disables the port.
Enables and disables flow control on the port. When flow control is enabled for the
port, the switch regulates the packet flow so that a sending device does not transmit
more packets than a receiving device can process. If flow control is disabled, packets
may be dropped under certain periods of high traffic. The possible values are:

No Change: Retains the current flow control status on the port.

Enabled: Enables flow control on the port.

Disabled: Disables flow control on the port.
Specifies the configured rate for the port. The port speed determines what speed
setting options are available. Port speeds can only be configured when
auto-negotiation is disabled. The possible field values are:

No Change: Retains the current port speed.

Auto: Use to automatically configure the port.

10: Indicates the port is currently operating at 10 Mbps.

100: Indicates the port is currently operating at 100 Mbps.

1000: Indicates the port is currently operating at 1000 Mbps.
Specifies the port duplex mode. The possible field values are:

No Change: Retains the current port duplex mode.
29