HP V1905 Series Getting Started Manual page 27

Removing ARP Entries

Viewing ARP Settings

Defining ARP Settings
The ARP Settings Setup Page allows network managers to define ARP parameters for specific interfaces.
Click Administration  ARP Settings  Setup. The ARP Settings Setup Page opens.
Figure 59 ARP Settings Setup Page
The ARP Settings Setup Page contains the following fields:
Table 49 ARP Settings Setup Page item description
Item
Interface
IP Address
MAC Address
ARP Entry Age Out
Removing ARP Entries
The ARP Entries Remove Page provides parameters for removing ARP entries from the ARP Table.
Click Administration  ARP Settings  Remove. The ARP Entries Remove Page opens.
Description
Indicates the management VLAN (VLAN 1) for which ARP parameters are defined.
Defines the static IP address, which is associated with the static MAC address.
Defines the static MAC address, which is associated with the static IP address.
Specifies the aging time for dynamic ARP entries. After the ARP Entry Age,
dynamic ARP entries are deleted from the table. The range is 1-40000000. The
default value is 1200 seconds.
22