HP V1905 Series Getting Started Manual page 95

Configuring LDB Parameters
On this page, you can enable or disable the LDB feature and configure the global LDB parameters.
Click Security  LDB  Setup. The LDB Setup Page opens.
Figure 129 Configure LDB parameters
Table 104 LDB parameter description
Item
Port Based Authentication State
Reauthentication Times
Sleep Period
Aging time
Description
Enable/disable port-based authentication globally.
Disabled by default.
NOTE:
The enabled LDB feature is effective on a port only after this item is

enabled.
 After successful authentication, the port is in Normal state.
Set the maximum number of authentication attempts.
3 by default
NOTE:
If the number of authentication attempts reaches the preset value but the
authentication still fails, the port connected to the user enters the Sleep state
for a period of time (sleep period).
Set the authentication sleep period.
5 minutes by default
NOTE:
Within the authentication sleep period, no users on this port are allowed to
try to pass authentication.
Set the aging time.
1 hour by default
90