HP V1905 Series Getting Started Manual page 14

Use this transceiver to connect the switch directly to a single mode fiber-optic cable or to multi-mode fiber
using a conditioned launch cable.
To activate the SFP port:
Hold the transceiver so that the fiber connector is toward you and the product label is visible, as shown
1.
in Figure
Figure 51 Inserting an SFP Transceiver
Gently slide the transceiver into the SFP slot until it clicks into place.
2.
CAUTION:
SFP transceivers are keyed and can be properly inserted only one way. If the transceiver does not click
when you insert it, remove it, turn it over, and reinsert it.
Remove the plastic protective cover, if fitted.
3.
Connect the fiber cable.
4.
Attach a male duplex LC connector on the network cable into the duplex LC connector on the
5.
transceiver.
Connect the other end of the cable to a device fitted with an appropriate Gigabit Ethernet connection.
6.
Check the Module Active LEDs on the front of the switch to ensure that the SFP transceiver is operating
7.
correctly.
Removing an SFP Transceiver
To remove an SFP transceiver:
Disconnect the cable from the transceiver.
1.
Move the wire release lever downwards until it is pointing toward you.
2.
Pull the wire release lever toward you to release the catch mechanism.
3.
The SFP transceiver should slide out easily.
51.Ensure the wire release lever is closed (in the upright position).
9