Connecting an External AIT 35 LVD Drive
This section describes the procedure to connect an external AIT 35 LVD drive to a
SCSI controller. When installing be sure to place the AIT 35 LVD drive on a flat,
sturdy surface such as a desk or tabletop.
NOTE: Do not place the unit on the floor. Allow enough space for proper ventilation and
easy access to the front and rear of the AIT 35 LVD drive. Allow at least 3 inches (7.6 cm)
between the rear of the unit and the wall.
WARNING: Risk of electrical shock. Do not attempt to open this product. There
are no user-serviceable parts inside. Refer all service to a Compaq Authorized
Service Provider.
Connecting the drive involves the following steps:
1. Shutting down the computer and all peripheral devices
2. Setting the SCSI ID
3. Connecting the drive
4. Powering on the peripherals
5. Powering on the computer
3
Chapter