Compaq AIT 35 LVD Reference Manual page 20

2-6 Compaq AIT 35 LVD Tape Drive Reference Guide
To install an AIT 35 LVD tape drive without drive rails:
1. Remove all screws from drive rails using a Torx T-10 screwdriver.
2. Slide the tape drive in an available removable media bay.
Figure 2-6. Installing an AIT 35 LVD drive without drive rails
3. Use the screws that were removed from the drive rails and insert two
of them into the threaded mounting holes on each side.
NOTE: Some computers may not be accessible on both sides. Secure the side(s)
that are accessible.