Compaq AIT 35 LVD Reference Manual page 51

3. If no firmware versions are available for download, click Skip. TSMC will
go straight to the download dialog, where you can manually specify a file for
download.
CAUTION: Make your selection carefully -- firmware dictates the behavior of
your device, and different firmware versions will each make your device behave
differently.
4. You will reach the download dialog if you answered No to the 'use database'
prompt or if you did not cancel the Available Updates dialog. As the
download dialog starts, it communicates with your device to determine the
optimal download parameters.
5. Before proceeding be sure to read the following cautions:
CAUTION: Do not interrupt the download process or eliminate power to the
device while the download process is running. Doing so may render your device
unusable.
CAUTION: ESL9000 and TL895 libraries use serial port downloads. Make sure a
serial cable is attached to the device and your host computer. If a download fails
to succeed, TSMC enforces a "forced re-download". Follow the directions on
your screen to complete the procedure.
IMPORTANT: The default parameters might be the ones that TSMC selects. You should
not change these settings.
NOTE: If selecting a firmware file from other than the Internet, it is recommended that
you put the file on a hard disk instead of reading it from a floppy.
TSMC determines download parameters for you when you select a firmware
file. If you must change download parameters, consult with Compaq support
personnel.
Your tape device may need to be in a specific state to receive new firmware.
For example, the media may need to be ejected prior to the firmware
download. Check your tape device documentation for specific instructions.
6. After specifying a file or arriving to this dialog after using the firmware
database click on Download. Do not interrupt the download process or
eliminate power to the device while the download process is running. Doing
so may render your device unusable.
NOTE: After firmware updates are made to devices, you should close and exit TSMC then
re-open it. This will properly update the device (library or drive) information, reflecting the
firmware update.
Troubleshooting Intel-based Computers 7-7