Sco Openserver; Configuring The Scsi Id For Sco Openserver - Compaq AIT 35 LVD Reference Manual

SCO OpenServer

The drivers required to support the AIT tape drive under SCO OpenServer are:
I
The SCO SCSI tape (stp) driver which is built into SCO OpenServer; see the
SCO System Administrator's Guide for information on how to configure the
driver.
I
An appropriate SCSI controller driver.
Drivers for the SCSI controllers and tape drive hardware are located on the Support
Software Diskettes and on the Compaq SmartStart and Support Software CD. The
Support Software ships with each computer or can be downloaded from the
Compaq website. The software tape device driver is located either with your tape
backup software or with the operating system. Refer to your backup application
installation guide for more information regarding additional software that might be
needed .
32-Bit Fast SCSI-2 Controllers
or 32-Bit Fast-Wide SCSI-2 Controllers
or Wide-Ultra SCSI Controllers
In addition, the appropriate version of the Compaq Extended Feature Supplement
(EFS) for SCO OpenServer is required:
I
For SCO OpenServer 5, use Compaq EFS version 5.16 or higher.
EFS for SCO OpenServer is available on both the Compaq SmartStart and Support
Software CD and is installed and configured automatically during a SmartStart
installation.

Configuring the SCSI ID for SCO OpenServer

In the pre-configured kernel used to install SCO OpenServer, the following SCSI
IDs are automatically set:
I
Disk = 0
I
Tape = 2
I
CD-ROM = 5
Table 4-3
SCO OpenServer
Controller
Installing the Software Drivers 4-5
Software Driver Information
Refer to the appropriate README on the
Compaq Support Software CD.
The name of the driver is CHA.