Preparing The Computer - Compaq AIT 35 LVD Reference Manual

2-4 Compaq AIT 35 LVD Tape Drive Reference Guide

Preparing the Computer

To set the SCSI ID, position the jumpers as shown in Figure 2-3.
SCSI ID
Key
Figure 2-3. Setting the SCSI ID jumpers on an internal AIT 35 LVD drive
To prepare the computer:
CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be
sure you are properly grounded before beginning this procedure. See Appendix
B, "Electrostatic Discharge" for further information.
1. Perform a normal system shutdown.
2. Power OFF the computer and all peripheral devices.
3. Disconnect the AC main power cord from the outlet, then from the computer
and from all peripheral devices.
4. Disassemble the system to expose the drive bay. Refer to the user manual
that came with your computer.
SCSI ID Settings
Bit 2 Bit 1 Bit 0