Installing the Internal AIT 35 LVD Drive
Your computer may differ slightly from the following illustrations, refer to the
documentation included with it.
To install the AIT 35 LVD tape drive with drive rails:
1. Slide the tape drive in an available removable media bay.
Figure 2-4. Installing an AIT 35 LVD drive with drive rails
2. Insert 2 screws in the front plate using a Torx T-15 screwdriver.
3. Connect an available power cable and the SCSI signal cable.
Figure 2-5. Connecting power and signal cables
Installing an Internal AIT 35 LVD Drive 2-5