Operating Instructions; Rev 11A - Chicago Electric 94071 Set Up And Operating Instructions Manual

OPERATING INSTRUCTIONS

FIGURE F
BUFFING
WHEEL
Movable
TOOL REST
POWER
SWITCH
1. Connect the Power Cord/Plug of
the Grinder to the nearest 120 volt,
grounded, electrical outlet.
(See Figure F.)
2. WARNING!
wear ANSI-approved safety
impact eye glasses underneath
an ANSI-approved safety
impact full face shield when
operating the Grinder.
3. Turn the Power Switch to its "ON"
position, and allow the Buffing
Wheel and Grinding Wheel to spin
up to full speed. (See Figure F.)
4. Place the object you are buffing or
grinding firmly against the Movable
Tool Rest and slowly feed the object
into the revolving Buffing Wheel or
Grinding Wheel. (See Figure F.)
5. CAUTION! Keep hands away
from the Buffing Wheel and Grinding
Wheel. Also, make sure to hold the
object you are buffing or grinding
firmly against the Movable Tool
Rest throughout the buffing/grinding
process. Failure to do so may
cause the object to be propelled
by the Buffing Wheel or Grinding
Wheel toward your body and/or
into the Grinder. (See Figure F.)
SKU 94071 For technical questions, please call 1-800-444-3353
GRINDING
WHEEL
OFF ON
ALWAYS
6. Once the grinding process is
competed, turn the Power Switch of
the Grinder to its "OFF" position. Do
not press against the Buffing Wheel
or Grinding Wheel to stop them
from spinning. Allow the Wheels to
completely stop on their own. Then,
disconnect the Power Cord/Plug from
its electrical outlet. (See Figure F.)
7. Keep the Grinder in an area
out of reach of children and
other unauthorized people.

REV 11a

PAGE 10