SPECIFICATIONS
Electrical Input
Arbor Shaft
No Load Speed
Mounting Holes
3168328
UNPACKING
When unpacking, check to make
sure all the parts shown on the Parts List
near the end of the manual are included.
If any parts are missing or broken, please
call Harbor Freight Tools at
1-800-444-3353 as soon as possible.
FIGURE E
SKU 94071
For technical questions, please call 1-800-444-3353
120 V~ / 1 A (Start)
1
/
"
2
3450 RPM
3/16" Diameter
OFF
ASSEMBLY INSTRUCTIONS
WARNING! Turn the Grinder off and
unplug it before assembly.
To Attach The Right
Movable Tool Rest:
1.
The left Movable Tool Rest
has been pre-attached by the
manufacturer. However, the right
Movable Tool Rest must be attached
by the operator prior to using
the Grinder. (See Figure E.)
2.
To attach the right Movable Tool
Rest, insert its mounting slot onto the
protruding, threaded Bolt located on
the front of the Grinder. Then, secure
the Movable Tool Rest, using the
Wing Nut. IMPORTANT: Adjust the
distance between the Movable Tool
Rest and Grinding Wheel to a 1/16"
or less separation. (See Figure E.)
RIGHT
SAFETY
GUARD
COVER
ON
WING NUT
FLAT WASHER
SPRING WASHER
MOVABLE TOOL REST
REV 11a
PAGE 8