Tool Set Up; Operating Instructions - Chicago Electric 97588 Set Up And Operating Instructions Manual

installing the auxiliary Handle
Do not operate this tool with
one hand only or without the
auxiliary Handle properly
installed.
7. The Auxiliary Handle may be installed
in one of three positions, on either
side or on top of the Gear Housing
(26). (See Photo.)
8. Screw the threaded end of the Auxil-
iary Handle into the selected position.
Tighten securely before beginning
work.
Functions
Auxiliary Handle (25)
Alternative Mounting
Positions for Auxiliary
Handle
Magnesium
Alloy Cover
Carbon Brush Cap (45)
Wheel Guard (7)
Quick Release Adjusting Nut (4)
Wheel Guard Quick Release (6)
This hand-held tool may be used for
grinding, sanding, scaling, and other
related operations.
SKU 97588
tO prevent
seriOus injury:
Spindle
Lock
Button
(24)
For technical questions, please call 1-800-444-3353.

Operating instructiOns

read the entire iMpOrtant
saFety inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.

tool set up

FrOM acciDental
OperatiOn:
turn the power switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
installing a grinding Wheel
1. Before installing a grinding wheel,
review the warnings on pages 5 - 7.
The Grinding Wheel MUST be:
• rated to at least 8000 RPM.
• no larger than 7" in diameter.
• fitted with a 7/8" round arbor hole.
• 3/8" thick or less.
• a type of grinding wheel suitable for
surface grinding, not edge grinding.
• dry and clean.
• proven undamaged by inspec-
tion and by the ring-test explained
below.
2. Press in and hold the Spindle Lock
Button (24) to prevent the Spindle (8)
from turning.
3. Remove the Outer Flange (1). Keep
the Inner Flange (3) in position on the
Spindle.
tO prevent
seriOus injury
Page 13