Specifications; Tool Set Up; Operating Instructions - Chicago Electric 40432 Set Up And Operating Instructions Manual

SpECIFICATIONS

Electrical Input 120 V~ / 60 Hz / .5 A (No Load)
Motor Speed 15,000 RPM (No Load)
Flexible Shaft 38"
Chuck Capacity 5/32"
uNpACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.

OpERATING INSTRuCTIONS

Read the ENTIRE IMpORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.

Tool Set up

FROM ACCIDENTAL
OpERATION:
Turn the power Switch of the tool
off and unplug the tool from its
electrical outlet before adjusting
tool or installing accessories.
1. Before operating, find a suitable spot
in the work area to attach the Holder
(1) and the Hanger (4). Drive two
(2) screws (not included) through the
Electric Rings and through the Holder.
Attach the Hanger to the Motor Housing
(7) with the two (2) Screws (6).
2. Inspect the Flexible Shaft (21) and make
certain that it is securely connected to
the Motor Housing Unit (7). Do not use
the Shaft at an angle greater than 90°.
Page 8
TO pREVENT
SERIOuS INjuRY
For technical questions, please call 1-800-444-3353.
Kinks or crimps in the shaft will result in
inefficient tool performance.
3. Attach the Foot Control. Insert the Plug
(29) into the Female Plug (28) which
comes off of the Foot Control (27). Insert
the Power Plug (26) into the receptacle.
4. Install a bit by using the Chuck Key (25)
to loosen the Drill Chuck (24). Insert bit
and then tighten the Drill Chuck by using
the Chuck Key.
Work piece and Work Area Set up
1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
2. Route the power cord along a safe
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
3. Secure loose work pieces using a vise
or clamps (not included) to prevent
movement while working.
4. There must not be objects, such as utility
lines, nearby that will present a hazard
while working.
REV 06g, 08l, 09e
SKU 40432