Operating Instructions; Tool Set Up - Chicago Electric 67648 Set Up And Operating Instructions Manual

OperAting inStructiOnS

read the entire iMpOrtAnt
SAFetY inFOrMAtiOn
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.

tool Set up

FrOM AccidentAl
OperAtiOn:
turn the power Switch of the tool
off and unplug the tool from its
electrical outlet before installing
accessories.
do not install a circular saw
blade, a wood carving blade,
carving disc with saw chain
cutters, or a cutting-carving disc
on this tool.
each accessory must have the
correct arbor size and must fit
properly on the shoulder
bushing. Make sure accessories
are tightened down securely.
installing the grinding wheel
1. The Grinding Wheel (Sold separately)
MUST be:
• rated to at least 8,000 RPM.
• no larger than 7" in diameter.
• fitted with a 7/8" round arbor hole.
• 1/4" thick or less.
• suitable for surface grinding, not edge
grinding.
• dry and clean.
• proven undamaged by inspection and
by the ring-test explained following.
Page 14
tO preVent
SeriOuS injurY
For technical questions, please call 1-800-444-3353.
2. Press in and hold the Spindle Lock
Button (21) to prevent the Spindle (6)
from turning.
3. Remove the Outer Flange (1). Keep
the Inner Flange (2) in position on the
Spindle.
4. Closely inspect the Grinding Wheel
before mounting. Perform a ring-test on
the wheel (unless wheel is smaller than
4" or is an unusual shape) as follows:
a. Suspend wheel using a pin or finger
through the arbor hole.
hang
wheel
from
pin
tap
wheel
here
b. Tap the flat side of the wheel with a
light non-metallic object, such as a
screwdriver handle, at a point 45° from
the vertical center line on each side of
the wheel and 1 – 2 inches from the
edge of the wheel (see Illustration).
c. Rotate the wheel 90° and repeat the
test until the entire wheel has been
checked.
d. An undamaged wheel will give a clear
tone. If cracked, there will be a dead
sound and not a clear ring.
5. For wheels with paper gaskets (blotters)
or metal gaskets: Slip the grinding wheel
onto the Spindle with the gasket first.
The gasket should be centered on the
grinding wheel and the wheel and gasket
45° 45°
V
e
r
t
i
c
A
l
c
e
n
t
e
r
45° 45°
SKU 67648