Sagem Fax Laser Pro 343 sms User Manual page 43

MFL 251 259 240A_MF34 Sagem Gb.book Page 9 Lundi, 24. mars 2003 2:50 14
Setting your machine
Your terminal is a new generation machine that will be part of your local network just like a PC.
Its built-in local network access card will enable you to send documents through an SMTP/POP3
local message server (internally or externally, depending on the settings of your message server).
To benefit from all the available network options, you should make the following settings,
described in the sections below:
• local network settings, to introduce your fax machine into your local network.
• message service settings, for all your faxes and E-mails to be automatically managed by
your message server.
Caution -
Although rather simple, network settings sometimes require a sound knowledge of
your own computer configuration. If that is administrated by anyone in your company, we
recommend you ask that person for the settings described below.
We recommend that you carry out a manual configuration of your terminal. The automatic
configuration of the local network settings may be considered, if your local network features a
DHCP or BOOTP server that can dynamically assign addresses to the peripheral devices present
on the LAN.
To automatically configure the local network settings:
+
Choose
DHCP or BOOTP server that can assign it its settings dynamically (the
message
+
Once the message
mask and Gateway address. If these are missing, you should carry out a manual
configuration (see below).
To configure your terminal manually, you should obtain the usual information used to set a
peripheral device (IP address, sub-network mask, network and gateway address).
To configure the local network setting manually:
+
Choose
Date en cours : 24 mars 2003
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFL-MFC-MFK\MFL 251 259 240A_LU FAX LASER PRO 343SMS_345SMS Sagem
GB\Setting your machine.fm
M 261 OK - SETUP / LOCAL NETWORK / CONFIGURATIO
and press OK to confirm. The terminal scans the local network for a
AUTOMATIC
is displayed).
SELF-CONF
has disappeared, check for the IP Address, Sub-network
SELF-CONF
M 261 OK - SETUP / LOCAL NETWORK / CONFIGURATIO
, and press OK to confirm.
MANUAL
3-9