Sagem Fax Laser Pro 343 sms User Manual page 103

MFL 251 259 240A_MF34 Sagem Gb.book Page 23 Lundi, 24. mars 2003 2:50 14
Maintenance
At switch-on nothing appears on screen
Check that the mains cable is plugged in, and check the mains plug if necessary.
The fax does not detect the presence of your inserted document. The message
not appear on the screen.
At the start and during scanning,
Remove the document or press key
Check the thickness of the document (30 sheets of paper of 80 g/m
Iron out the sheets if needed.
Help the sheets along.
The fax machine does not receive any faxes
Check that the telephone line cable is correctly plugged in and that there is a tone signal on the
telephone line by means of the
You receive a blank page
Make a photocopy of a document ; if it is correct then your fax is functioning normally. Call back
the subscriber and have him resend the document. It was probably sent with the sheet inserted
backwards.
You cannot send a fax
Check that the telephone line cable is correctly plugged in.
Check the tone by pressing key
Check the prefix is correctly programmed and used.
Always use the original package when transporting the machine. Failure to do so could void the
warranty.
+
1 - Disconnect the machine from the telephone network and the AC power socket
+
2 - Open the front cover
+
3 - Shut the front cover. Unplug the phone line cord and the AC power cord, the document
holder and the document stacker. Put them in the original package
Date en cours : 24 mars 2003
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFL-MFC-MFK\MFL 251 259 240A_LU FAX LASER PRO 343SMS_345SMS Sagem
GB\Maintenance Gb.fm
REMOVE DOCUMENT appears on the screen.
.
2
key.
.
6-23
does
READY
).