Error Codes - Henny Penny OFG-392 Technical Manual

1-4. ERROR CODES

DISPLAY
"E04" Control board overheating
"E05" Shortening overheating
"E06" Temperature probe failure
"E41" Programming failure
"E71" Pump motor relay failure or
wiring problem
Air pressure switch open; clogged
"E32,
CHECK dilution box or faulty blower; open
HIGH LIMIT,
drain switch; open high limit; open
DRAIN VALVE,
vacuum switch
VACUUM SWITCH,
BLOWER MOTOR"
1-10
In the event of a control system failure, the digital display shows an
error message. These messages are coded: "E04", "E05", "E06",
"E32", "E41" and "E71". A constant tone is heard when an error
code is displayed, and to silence this tone, press any of the product
buttons.
CAUSE PANEL BOARD CORRECTION
Turn switch to OFF position, then turn
switch back to ON; if display still shows
"E04", the board is getting too hot; check for
signs of overheating behind the control
panel; once panel cools down the controls
should return to normal; if "E04" persists,
replace the control
Turn switch to OFF position, then back to
ON; if display shows "E05", the heating
circuits and temperature probe should be
checked; once the unit cools down, the
controls should return to normal; if "E05"
persists, replace the controls
Turn switch to OFF position, then back to
ON; if the display shows "E06", the tempera-
ture probe should be checked; once the
probe is repaired, or replaced, the controls
should return to normal; if "E06" persists,
replace the controls
Turn switch to OFF position, then back to
ON; if display shows "E41", the control
should be re-initialized (See programming
section); if the error code persists, replace
the control panel
Replace relay if contacts are stuck closed;
check wiring on POWER/PUMP switch, or at
wall receptacle; L1 and N may be reversed
Clean dilution box or replace blower if
necessary; have drain switch checked; reset
high limit or have high limit checked; check
vacuum switch
Model OFG- 390
806