Henny Penny OFG-392 Technical Manual page 25

2-8. LID COUNTERWEIGHT
CABLES (Continued)
1003
8. Remove the bolts and spacers securing the pulley bracket, and
pull bracket back, to allow access to cable bracket.
9. Pull cable and bracket from unit and remove cable from bracket.
10. Remove cable from weight frame.
11. Thread new cable through pulley.
12. Thread nut on cable and place cable through weight frame.
13. Thread second nut onto end of cable, but do not tighten.
14. Thread nut on other end of cable and place through the
bracket, then thread a second nut on the end of the cable. Use
the hole in bracket, that is towards the front of the cooker, when
mounted. Tighten the nut to the bracket. 2 inches of the threaded
cable end, should show above the bracket. See photo below.
2 inches (50.8 mm)
Both cables should have the same amount of threads extending
through the brackets.
15. Tighten cable onto weight frame.
16. Reassemble in reverse order.
Be sure to use pipe sealant on the pipe fittings.
Model OFG- 390
2-8