Table of Contents
Advertisement
3-16. SPECIAL PROGRAM
MODE
3-27
The Special Program mode is used to set more detailed
parameters listed below.
SP-1
· Degrees Fahrenheit or Celsius
SP-2
· Language: English, French, German,
Spanish, and Portuguese
SP-3
· System initialization
SP-4
· Audio volume
SP-5
· Audio tone
SP-6
· Type of shortening to be melted - liquid, solid
SP-7
· Idle Mode
SP-8
· Filter Tracking
SP-9
· Product buttons
SP-10
· Clean-out minutes
SP-11
· Clean-out temperature
SP-12
· Nominal amps reading
SP-13
· Amps reading low limit (percentage)
SP-14
· Amps reading high limit (percentage)
SP-15
· Program code change
SP-16
· Usage code change
SP-17
· Change shortening - A-Cook Cycles
SP-18
· Change shortening - B-Hours
1.
Press and hold
"L-2" and "LEVEL 2", followed by, "SP PROG" and
"ENTER CODE shows in the display.
2.
Enter code 1, 2, 3, and "SP- 1 ", "TEMP, UNITS"
shows in the display.
If a bad code is entered, an alarm sounds and "BAD
CODE" shows on the display. Wait a few seconds,
the control reverts back to the Cook Cycle, and
repeat the above steps.
To exit from the Special Program Mode at any time, press
and hold
button for 2 seconds, or to roll back to
previous setting, press
Degrees Fahrenheit or Celsius (SP-1)
a. Follow steps 1 and 2 above.
b. The display flashes "SP- 1" and "TEMP, UNITS", along
with "ºF" or "ºC". Press
"ºF" to "ºC", or vice versa.
Model OFE- 291
for 5 seconds until
.
to toggle from
1005
Advertisement
Table of Contents
