Table of Contents
Advertisement
3-16. SPECIAL PROGRAM
MODE (Continued)
1005
Program Code Change (SP-15)
This allows the operator to change the program code (factory
set at 1, 2, 3) used to access Product Programming, Special
Programming, Clock Set, Data Comm, and Heat Control Modes.
a. Follows steps 1 and 2 above.
b. Press
until "SP-15" and "CHANGE, MGR CODE,
1=YES" shows in display, along with "CODE".
c. Press
. "ENTER NEW CODE, P=DONE, I=QUIT"
shows in display. Press product buttons with new code.
d. If satisfied with code, press
CODE, P=DONE, I=QUIT, shows in display. Press same
code buttons in step c.
e. If satisfied with code, press
shows in display.
f. If not satisfied with code, press
shows in display, then reverts back to "SP-15" and
CHANGE, MGR CODE, 1=YES". Then the above steps
can be repeated.
Press and hold
Mode.
Usage Code Change (SP-16)
This allows the operator to change the reset usage code
(factory set at 1, 2, 3) to reset the usage amounts of each
product. See Review Usage step in Information Mode.
a. Follow steps 1 and 2 above.
b. Press
until "SP-16" and "CHANGE, USG CODE ?
1=YES" shows in display, along with "USAGE".
c. Press
, "ENTER NEW CODE, P=DONE, I=QUIT"
shows in display. Press product buttons with new code.
d. If satisfied with code, press
CODE, P=DONE, I=QUIT" shows in display. Press same
code buttons in step c.
Model OFE- 291
. "REPEAT NEW
. *CODE CHANGE*
and *CANCELLED*
at any time to exit Special Program
. "REPEAT NEW
3-34
Advertisement
Table of Contents
