Table of Contents
Advertisement
32 www.electrolux.com
12.3 Cleaning the door
13. WHAT TO DO IF...
WARNING!
Refer to the Safety chapters.
Problem
The appliance does
not heat up.
A
45°
Possible cause
The appliance is deactiva-
ted.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
5.
Install the left shelf support.
To clean the door remove it.
A
Removing the door
1.
Open the door as far as it goes.
2.
Fully press the clamping levers (A) on
the two door hinges.
3.
Close the door until it is at an angle
of approximately 45°.
4.
Hold the door with one hand on each
side and pull it away from the appli-
ance at an upwards angle.
Installing the door
To install the door do the above steps in
the opposite sequence.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
Remedy
Activate the appliance.
Advertisement
Table of Contents
