Command Interface - CyberData 11113 Operation Manual

2.4 Command Interface

Some functions on the Intercom can be activated using simple POST commands to the web interface.
The examples in
commands to the device should work.
Note
Device Action
To trigger the relay
(for the configured delay)
To cause the Intercom to place a
call to extension 130
To terminate an active call
To force the Intercom to reboot
To play the test audio file
To cause the Intercom to speak
it's ip address
a.Type and enter all of each http POST command on one line.
Operations Guide
Table 2-21 use the free unix utility, wget, but any program that can send http POST
These commands require an authenticated session (a valid username and password to
work).
Table 2-21. Command Interface Post Commands
930323G
Installing the VoIP Indoor Intercom with Keypad
a
HTTP Post Command
wget --user admin --password admin --post-data "test_relay=yes"
"http://10.0.3.78/cgi-bin/command.cgi" > /dev/null
wget --user admin --password admin --post-data "call=130"
"http://10.0.3.78/cgi-bin/command.cgi" > /dev/null
wget --user admin --password admin --post-data "terminate=yes"
"http://10.0.3.78/cgi-bin/command.cgi" > /dev/null
wget --user admin --password admin --post-data "reboot=yes"
"http://10.0.3.78/cgi-bin/command.cgi" > /dev/null
wget --user admin --password admin --post-data "test_audio=yes"
"http://10.0.3.78/cgi-bin/command.cgi" > /dev/null
wget --user admin --password admin --post-data
"speak_ip_address=yes"
"http://10.0.3.78/cgi-bin/command.cgi" > /dev/null
Parts List
CyberData Corporation
63