Appliance Preparation; Securing And Leveling The Appliance - Heat & Glo Crescent II Owner's Manual

7

Appliance Preparation

A. Securing and Leveling the Appliance
WARNING
Fire Risk.
• Prevent contact with sagging, loose
insulation.
• Do NOT install against vapor barriers or
exposed insulation.
CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses
during installation.
The diagram shows how to properly position, level, and se-
cure the appliance (see Figure 7.1). Nailing tabs are provid-
ed to secure the appliance to the framing members.
NAILING TABS
BOTH SIDES
2 HOLES IN BASE FOR
MOUNTING TO FLOOR
Figure 7.1 Proper Positioning, Leveling and
Securing of a Appliance
• Place the appliance into position.
• Level the appliance from side to side and front to back.
• Shim the appliance with noncombustible material, such
as sheet metal, as necessary.
• Remove two side screws from each nailing tab (see
Figure 7.2) and refasten nailing tabs to the appliance.
Note: Return bend on nailing tab faces back of unit.
• Keep nailing tabs flush with the framing.
• Secure the appliance to the framing by using nails or screws
through the nailing tabs.
• Holes are also provided in appliance bottom to secure
appliance to floor.
18 Heat & Glo • Crescent II • 2083-902 Rev. G • 9/05
FRONT
VIEW
REMOVE
SCREWS (2)
NAILING
TAB
TOP
VIEW
DETAIL A
RETURN BEND FACES
THE BACK OF THE UNIT
Figure 7.2 Nailing tabs
WARNING
Fire Risk.
• ALWAYS maintain specified
clearances around the appliance.
• Do NOT notch into the framing around the appliance spacers.
Failure to keep insulation, framing or other material away
from the appliance may cause fire.
BACK
VIEW
REFASTEN
NAILING
TAB
SCREWS (2)