Glass Assembly; Replacing Light Bulb - Heat & Glo Crescent II Owner's Manual

E. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete
appliance.
Removing Glass
Assembly
Pull the two glass as-
sembly latches out of
the groove on the
glass frame. Remove
glass door from the
appliance (see Figure
12.10).
Replacing Glass
Assembly
Replace the glass
door on the appli-
ance. Slide the top of
glass into slot at top.
Pull out and latch the
two glass latches into
the groove on the
glass frame.
F. Replacing Light Bulb
WARNING
HOT! DO NOT TOUCH.
BURNS MAY RESULT.
• Glass and other surfaces are hot during operation
and cool down.
• Do NOT change bulb when appliance is hot.
36
BRACKET
WITH SLOT
GLASS
ASSEMBLY
Figure 12.10 Glass Assembly
Heat & Glo • Crescent II • 2083-902 Rev. G • 9/05
CAUTION
Avoid damaging light bulb or glass.
• Use cotton gloves or rag to handle bulb. (Oil film on
bulb, including skins oils, will cause premature
failure of bulb.)
• Ensure lava rock and clear rock is not under glass
when reinstalling.
• Do NOT overtighten screws.
• Remove logs and burner from appliance, by removing
two screws holding the pilot in place, and two screws
holding the burner in place (see Figure 12.11).
BURNER SCREWS (2)
EMBER GLASS SCREWS (3)
Figure 12.11 Burner Pilot and Glass Attachment
• Remove clear rock and lava rock from orange film and
around edge of ember glass.
• Remove four long sheetmetal screws holding the orange
film.
• Remove glass and orange film from bottom of appliance.
• Remove old light bulb and replace it with a new bulb (see
Figure 12.12). Recommended replacement: Sylvania
Candelabra 75 watts.
LIGHTBULB
Figure 12.12 Light Bulb Location
• Reinstall the glass, orange film, burner and logs, lava
and clear rocks. For placement of logs and rock refer to
the log placement instructions in Section 12-D.
PILOT SCREWS (2)