Heat & Glo Crescent II Owner's Manual page 24

Assembling and Installing Storm Collar
CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses
during installation.
Connect both halves of the storm collar with two screws
(see Figure 8.15).
Wrap the storm collar around the exposed pipe section
and align brackets. Insert a bolt (provided) through the
brackets and tighten nut to complete storm collar assembly
(see Figure 8.16).
Slide the assembled storm collar down the pipe section
until it rests on the roof flashing.
Caulk around the top of the storm collar (see Figure 8.14).
Figure 8.15 Assembling the Storm Collar
24 Heat & Glo • Crescent II • 2083-902 Rev. G • 9/05
Figure 8.16 Assembling the Storm Collar Around the Pipe