Table of Contents
Advertisement
9
Appliance Preparation
A. Top Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
Figure 9.1 Rotate the top heat shield to the vertical
position as shown above. The heat shield must remain in
the vertical position.
WARNING! Risk of Fire! Do not remove heat shield. El-
evated header temperatures could cause a fire.
Heat & Glo • 350TSI-P-CEM • 2033-973 Rev. G • 4/17
Note: Actual unit may look different than the fireplace
shown in this section.
Figure 9.2 To attach the first section of vent pipe, make
sure to use the fiberglass gasket to seal between the first
vent component and the outer fireplace wrap. Use 2 self
tapping screws to secure the gasket to the outer wrap.
Note: Once the seal cap has been removed, it cannot be
reattached.
37
Advertisement
Table of Contents
