Appliance Setup; Remove Shipping Materials; Section 12: Appliance Setup A. Remove Shipping Materials; Clean The Appliance - Heat & Glo Crescent II Owner's Manual

Installation and operation

Hide thumbs Also See for Crescent II:

Table of Contents

Appliance Setup

A. Remove Shipping Materials

Remove shipping materials from inside and underneath the

firebox. A shipping bracket on the bottom front face must

be removed. Remove the screws and shipping bracket and

discard (see Figure 12.1).

Figure 12.1

SHIPPING

BRACKET

REMOVE (4) NUTS

AND SHIPPING BRACKET

Heat & Glo • Crescent II • 2083-902 Rev. G • 9/05

B. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated

inside the firebox or underneath in the control cavity.

C. Accessories

Install approved accessories per instructions included with

accessories. See Service Parts List for appropriate ac-

cessories. Refer to Section 16.

WARNING

Shock or fire risk.

Use ONLY optional accessories approved for

this appliance.

• Using non-listed accessories voids

warranty.

• Using non-listed accessories may result in

a safety hazard.

• Only Hearth & Home Technologies

approved accessories may be used safely.

Table of Contents