After Appliance Is Lit; Frequently Asked Questions - Heat & Glo Crescent II Owner's Manual

C. After Appliance is Lit
Initial Break-in Procedure
When you light the appliance, you may notice that it pro-
duces heat which does have an associated odor or smell.
If you feel this odor is excessive it may require the initial
three to four hour continuous burn on high followed by a
second burn up to 12 hours to fully drive off any odor from
paint and lubricants used in the manufacturing process.
Condensation of the glass is normal.
NOTE: The appliance should be run three to four hours
on the initial start-up. Turn it off and let it cool completely.
Remove and clean the glass. Replace the glass and run
the appliance for an additional 12 hours. This will help to
cure the products used in the paint and logs.
During this break-in period it is recommended that some win-
dows in the house be opened for air circulation. This will help
avoid setting off smoke detectors, and help eliminate any
odors associated with the appliance's initial burning.
WARNING
Fire Risk.
High Temperatures.
Keep combustible household items away from appliance.
Do NOT obstruct combustion and ventilation air.
• Do NOT place combustible items on top of or in front
of appliance.
• Keep furniture, draperies away from appliance.
D. Frequently Asked Questions
ISSUE
Condensation on the glass
Blue flames
Odor from appliance
Film on the glass
Metallic noise
Is it normal to see the pilot flame
burn continually?
This is a result of gas combustion and temperature variations. As the appliance
warms, this condensation will disappear.
This is a result of normal operation and the flames will begin to yellow as the
appliance is allowed to burn for 20 to 40 minutes.
When first operated, this appliance may release an odor for the first several hours.
This is caused by the curing of the paint and the burning off of any oils remaining
from manufacturing. Odor may also be released from finishing materials and
adhesives used around the fireplace.
This is a normal result of the curing process of the paint and logs. Glass should be
cleaned within 3 to 4 hours of initial burning to remove deposits left by oils from the
manufacturing process. A non-abrasive cleaner such as gas fireplace glass cleaner
may be necessary. See your dealer.
Noise is caused by metal expanding and contracting as it heats up and cools down,
similar to the sound produced by a furnace or heating duct. This noise does not affect
the operation or longevity of the fireplace.
In an Intellifire ignition system it is normal to see the pilot flame, but it should turn off
when ON/OFF is turned off. In a standing pilot system the pilot will always stay on.
Heat & Glo • Crescent II • 2083-902 Rev. G • 9/05
CAUTION
• Prevent accidental appliance operation when not
attended.
• Unplug or remove batteries from remote control if
absent or if appliance will not be used for an extended
period of time.
• Property damage possible from elevated temperatures.
CAUTION
Smoke and odors released during initial operation.
• Open windows for air circulation.
• Leave room during initial operation.
• Smoke may set off smoke detectors.
Smoke and odors may be irritating to sensitive
individuals.
WARNING
Fire Hazard.
Keep combustible materials, gasoline
and other flammable vapors and liquids
clear of appliance.
• Do NOT store flammable materials in the appliance's
vicinity.
• Do NOT use gasoline, lantern fuel, kerosene, charcoal
lighter fluid or similar liquids in this appliance.
• Combustible materials may ignite.
SOLUTIONS
39