Positioning The Logs - Heat & Glo Crescent II Owner's Manual

D. Positioning the Logs
Log Set Assembly: LOGS-Crescent II
CAUTION: Logs are fragile.
RUBBER
BANDS
Figure 12.2
STEP 1: Remove the rubber band from the log set and the
packing around the log. Check to see if the back lighting /
ember bed bulb works. See Replacing Light Bulb (Section
12.F) in manual if bulb needs to be replaced.
Figure 12.5
STEP 3: Place log (SRV2083-181) on right side of burner
between burner and firebox, and tip the log so it rests on the
burner tube.
34
Figure 12.1
REMOVE
PACKING
STEP 2: LOG REPLACEMENT ONLY: Remove old log set
from fireplace by removing two screws holding the pilot and
two screws holding burner in firebox. Remove old logs and
burner. Slide the new log set over the orifice and make sure
the orifice engages into the burner neck. Then install two
screws holding the pilot to the burner and two screws holding
burner to bottom of fireplace.
STEP 4: Place clear rock on top of orange film in front of
log set. It is recommended using the clear rock which is no
bigger than one inch.
Heat & Glo • Crescent II • 2083-902 Rev. G • 9/05
BURNER
SCREWS
LOGS NOT SHOWN IN PICTURE
Figure 12.3
LOCATION OF
CLEAR ROCK
Figure 12.6
PILOT
SCREWS
2083-903